CPC-8-BRK Installation Instructions

Follow the attachment below to properly install a CPC-8-BRK.

Tools required:

#2 Phillips Drive Screw driver or #2 Square bit drive

Parts Included:

(1) Power Cord Set
(1) Cord Hook Bracket
(1) Power Cord Bracket Set
(4) #10 x 3/4” Long Pan Head Phillips Drive Recex Low Root Screws
(2) 1/4-20 x 5/8” Long Pan Head Phillips Drive Machine Screws
(1) Cord Clamp

1. Before attaching the Power Cord Set and brackets to worksurface, arrange brackets onto power cord. (See Fig.A)

2. While holding brackets in place, fasten left-handed bracket from underneath the worksurface. Align with pre-drilled holes and fasten (2) #10 x 3/4” Long Pan Head Phillips Drive screws into the (2) four locations (See Fig. B).

3. Finish attachment by aligning remaing pre-drilled holes and fasten (2) #10 x 3/4” Long Pan Head Phillips Drive screws into the (2) four locations (See Fig. C).

4. Attach cord clamp with one (1) #1/4 20 x 5/8” Long Pan Head Phillips Drive Screw into the back side of cord tray (See Fig. D)

5. Attach Cord Hook from underneath the worksurface using (2) #10 x 3/4” Long Pan Head Phillips Drive Recex Low Root Screws (See Fig.E)