CT-B Installation Instructions

Follow the attachment below to properly install a CT-B.

Tools required:
#2 Phillips Drive Screw driver or #2 Square bit drive

Parts Included:
(1) Cord Tray
(4) #10 x 3/4” Long Pan Head Phillips Drive Recex Screws
(2) #10-24 x 7/8” Long Pan Head Phillips Drive Machine Screws

2. From underneath the worksurface, align cord tray with pre-drilled holes in worksurface. Once aligned, fasten (4) #10 x 3/4” Long Pan Head Phillips Drive screws into the front (4) four locations
(See Fig. A). Finish attachment by placing
and attaching last two (2) #10-24 x 7/8” Long Pan Head Phillips Drive Screws into the back side of cord tray (See Fig. B)

1. Before installing the cord tray, run all cables through alloted grommet holes. They may have to be installed in reverse due to the size of cable ends. Fig. C shows the grommet hole for the following: 3-plug outlet cable
AC-In Cable
Grey cat. 5 cable
Black cat. 5 cable
USB cable Fig. D shows (2) entry ways
(one needed) for the coiled power cord. Once all cables have been installed within the cord tray, proceed to install tray to worksurface.